Firestone QuickSeam Pipe Flashing - W563581063

Stock Availability:
48
SKU:
W563581063
$141.00

A stepped down boot for adhering onto the EPDM rubber liner to seal a pipe penetration through the liner. Primarily used for roofing applications.

Please watch the Instructional Videos below.

Firestone QuickSeam Pre-Moulded Pipe Penetration Boot

Base: Molded EPDM
Colour: Black
Sizes: Universal - fits 1" O.D. to 6 7/8" O.D. (25.4mm - 174.6mm)
Clamp: Stainless Steel - clamp is included
Pipe Flange: 13" (33cm) O.D.
Thickness 1.4-1.9mm (0.055" - 0.075")

Fits these pipe diameters:
1"- 1 3/8" (25.4 - 34.9mm)
1 5/8" - 1 7/8" (41.3 - 47.6mm)
2" - 2 5/8" (50.8 - 66.7mm)
2 3/4" - 3 5/8" (69.8 - 92.1mm)
4" - 4 1/2" (102 - 114mm)
5" - 5 1/2" (127 - 141mm)
6" - 6 7/8" (152.4 - 174.6mm)

Please note:

For correct application of this boot you must prepare the mating raw EPDM surface with Firestone QuickPrime Plus EPDM Seam Primer applied with a  Firestone QuickScrubber Tool Set or a clean Scotchbright type plastic scouring pad. The pipe is sealed to the pipe flashing with Firestone Water Block Seal (S20). The final detail requires Firestone Lap Sealant HS applied around the top edge where the pipe comes through as shown in the video. We would also suggest it's application around the perimeter of the flange.

Video: How to install a Firestone QuickSeam Pipe Flashing boot

pdf
(Size: 126.2 KB)
Write Your Own Review
You're reviewing:Firestone QuickSeam Pipe Flashing - W563581063
Your Rating